Lenze i510 - Optical Device Identification

6.8 Opcal device idencaon
For applicaons including several interconnected inverters it may be dicult to locate a device
that has been connected online. The "Opcal device
idencaon" funcon serves to locate
the inverter by means of blinking LEDs.
Parameter Name / value range / [default seng] Info
0x2021:001
(PAR 230/001)
Opcal device idencaon: St
art detecon
(Opt.dev.det.: Opt.det: start)
1 = start opcal device idencaon.
•
Aer the start-up, the two "RDY" and "ERR" LEDs on the front of the
inverter are blinking at a blinking frequency of 20 Hz for the blinking
duraon set in 0x2021:2. Then the seng is automacally reset to
"0".
•
If the funcon is reacvated within the blinking me set, the me is
extended correspondingly.
•
A manual reset to "0" makes it possible to stop the funcon prema-
turely.
0 Stop
1 Start
0x2021:002
(PAR 230/002)
Opcal device idencaon: Blinking duraon
(Opt.dev.det.: Opt.det: me)
0 ... [5] ... 3600 s
Basic seng
Opcal device idencaon
76
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.actechdrives.com - Email: info@actechdrives.com