Lenze i510 - Keypad Setpoint Source; Network Setpoint Source

11.3.3 Keypad setpoint source
The following funcon is used to select the keypad as setpoint source.
Precondions
A setpoint change-over to the keypad is only eected if no setpoint source with a higher prior-
ity has been selected. 4Priority of the setpoint sour
ces^ 193
Parameter Name / value range / [default seng] Info
0x2631:016
(PAR 400/016)
Funcon assignment: Setpoint = K
eypad
(Funcon list: Setpoint=Keypad)
•
For possible sengs see descripon for
0x2631:001 (PAR 400/001). ^ 188
Assignment of a trigger for the "Setpoint = Keypad" funcon.
Trigger = TRUE: the keypad is used as setpoint source (if the trigger
assigned has the highest setpoint priority).
Trigger = FALSE: no acon / deacvate funcon again.
Notes:
•
The default keypad setpoint can be changed in keypad operang
mode via the arrow keys of the keypad.
00 Not connected No trigger assigned (trigger is constantly FALSE).
11.3.4 Network setpoint source
Generally, the network can be oponally set as standard-setpoint source or, aer correspond-
ing conguraon via a bit of the mappable NETWordIN1 data word, can be acvated as set-
point source.
Precondions
A setpoint chang
e-over to the network is only eected if no setpoint source with a higher pri-
ority has been selected. 4Priority of the setpoint sources^ 193
Details
•
In order to generally se
t the network as standard setpoint source, go to 0x2860:001
(PAR 201/001) and set the selecon "5: Network".
•
If a bit of the mappable NETWordIN1 data w
ord is to be used for acvaon, use 0x400E:001
(PAR 505/001)to assign funcon "17: Setpoint = Network" to the corresponding bit of NET-
WordIN1. 4General network sengs^ 97
•
There is no specic funcon with a selectable trigger for a setpoint change-over to the net-
work.
Flexible I/O conguraon
Setpoint change-over
Keypad setpoint sour
ce
194
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.actechdrives.com - Email: info@actechdrives.com