Lenze i510 - 13 Appendix; Changing the Parameter Settings Using the Keypad

13 Appendix
13.1 Changing the parameter sengs using the k
eypad
Keypad operang mode
Aer switching on the inverter, the keypad plugged in is in "Operang mode" aer a short
inialisaon phase.
In the operang mode,
•
the keypad can be used for local control and for manual setpoint selecon.
•
the keypad displays some informaon on the in
verter status (see the following table).
Meaning of the keypad status displays
Keypad display Display Meaning
If the inverter is inhibited, the keypad shows "STOP":
STOP
MAN AUTO SETLOC REM
VEL:FLEX:AIN1



If the inverter is enabled, the ke
ypad shows the output
frequency of the inverter:
200
MAN AUTO SETLOC REM
HzVEL:RUN:FWD


•
In PID mode, instead of the output frequency the PID
setpoin
t is shown.
•
The display can be congured in 0x2864 (PAR 703).
❶
Acve control mode:
VEL Speed mode
PID Pr
ocess controller mode
TRQ Torque mode
TSTx Test mode x
JOG Manual mode
❷
Acve control source:
FLEX Flexible I/O conguraon
KPD Keypad
NET Network
TSTx Test mode x
❸
Acve setpoint source:
AINx Analog input x
KPD Keypad
NET Network
FREQ Digital frequency
PRx Preset setpoint x
SEGx Segment x
MOP Motor potenometer
❹
Current direcon of rotaon:
FWD Motor is rotang forwards
REV Motor is rotang backwards
❺
Lower sta
tus line:
LOC Local keypad control acve.
REM Remote control via terminals, network, etc. acve.
MAN Manual setpoint selecon via keypad acve.
AUTO Automac setpoint selecon via terminals, network, etc. acve.
SET Blinking if one parameter seng has been changed but has not been
saved in the memory module with mains failur
e protecon.
Save sengs: press keypad "Enter" key > 3 s.
If a fault is pending, the keypad shows the following infor-
maon:
WFF15
MAN AUTO SETLOC REM
W.UV dc link

 
•
Warnings (W) are only displayed e
very 2 seconds for a
short me.
•
Trouble (T) and faults (F) are displayed connuously.
❶
Message text
❷
Response:
W Warning
T Trouble
F Fault
❸
Error code
Appendix
Changing the parameter sengs using the k
eypad
226
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.actechdrives.com - Email: info@actechdrives.com