Lenze i510 - Releasing Holding Brake Manually

11.6 Releasing holding brake manually
The "Release holding brake" funcon is used to release the holding brake manually.
Precondions
•
Ob
ser
v
e seng and applicaon not
es in the "Holding br
ake contr
ol" chapter! ^ 180
•
The operang mode of the holding brake control has to be set in 0x2820:001 (PAR 712/001)
to "Manual [1]".
•
The "Release holding brake [115]" trigger has to be assigned to a digital output or, in the
simplest case, to the relay which then switches the brake supply.
Details
Detailed informaon about the funcon and conguraon of the holding brake control can be
found in the "Holding brake control" chapter. ^ 180
Parameter Name / value range / [default seng] Info
0x2631:049
(PAR 400/049)
Funcon assignment: Release holding brak
e
(Funcon list: Release brake)
•
Seng can only be changed if controller inhibit is
acve.
•
For possible sengs see descripon for
0x2631:001 (PAR 400/001). ^ 188
Assignment of a trigger for the "Release holding brake" funcon.
Trigger = TRUE: release holding brake in manual mode.
Trigger = FALSE: no acon.
Notes:
•
Funcon is only executed if the operang mode of the holding brake
in 0x2820:001 (PAR 712/001) is set to "Manual [1]".
00 Not connected No trigger assigned (trigger is constantly FALSE).
Flexible I/O conguraon
Releasing holding brake manually
203
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.actechdrives.com - Email: info@actechdrives.com