Lenze i510 - Default Control Setup

4.4.4 Funcon assignment of the inputs and outputs
The inverter control can be adapted individually to the respecve applicaon. This is basically
eected by assigning digital control sources ("triggers") to funcons of the inverter.
By default, the inverter can be controlled via the I/O terminals as follows:
t
t
t
t
t
0 Hz
30 Hz
10 Hz
20 Hz
40 Hz
50 Hz
60 Hz
0 Hz
30 Hz
10 Hz
20 Hz
40 Hz
50 Hz
60 Hz
-40 Hz
-60 Hz
-50 Hz
-30 Hz
-20 Hz
-10 Hz
t
t
❶
❷
❸
❹
❺
❻
❼
t
t
t
t
Braking function is switched off in default setting of 0x2820:001.
Presets 1 ... 3Preset 1
RelayReady
Digital output 1Release brake
Output signals
Output
Trigger
Motor speed
Preset val. select. bit 1
Preset val. select. bit 0
Reversal
Reset error
Start enable
Digital input 5
Digital input 4
Digital input 3
Digital input 2
Digital input 1
Input signals
Frequency setpoint selection
via analog input 1
Mains voltage
Error status
FunctionTrigger
Parameter Name Lenze seng
❶
0x2631:002 (PAR 400/002) Start enable 11: digital input 1
❷
0x2631:004 (PAR 400/004) Reset error 12: digital input 2
❸
0x2631:013 (PAR 400/013) Reversal 13: digital input 3
❹
0x2631:018 (PAR 400/018) Preset val. selecon bit 0 14: digital input 4
❺
0x2631:019 (PAR 400/019) Preset val. selecon bit 1 15: digital input 5
❻
0x2634:001 (PAR 420/001) Relay 51: Ready for operaon
❼
0x2634:002 (PAR 420/002) Digital output 1 115: Release holding brake
①
0x2860:001 (PAR 201/001) Frequency setpoint source 2: analog input 1
②
0x2911:001 (PAR 450/001) Preset frequency values: Preset value 1 20 Hz
③
0x2911:002 (PAR 450/002) Preset frequency values: Preset value 2 40 Hz
④
0x2911:003 (PAR 450/003) Preset frequency values: Preset value 3 50 Hz
⑤
0x2917 (PAR 220) Acceleraon me 1 5.0 s
⑥
0x2918 (PAR 221) Deceleraon me 1 5.0 s
Commissioning
Parameter seng
Funcon assignmen
t of the inputs and outputs
21
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.actechdrives.com - Email: info@actechdrives.com