Lexmark MX912dxe - Insert Tray [X]; Insufficient Memory for Flash Memory Defragment Operation [37]; Insufficient Memory to Collate Job [37]; Insufficient Memory to Support Resource Save Feature [35]

Insert Tray [x]
Try one or more of the following:
• Insert the specified tray into the printer.
• Cancel the print job.
• Reset the active bin for a linked set of bins by selecting Reset active bin on the printer control panel.
Insufficient memory for Flash Memory Defragment operation [37]
Try one or more of the following:
• From the printer control panel, touch Continue to stop the defragmentation and continue printing.
• Delete fonts, macros, and other data in the printer memory.
• Install additional printer memory.
Insufficient memory to collate job [37]
Try one or more of the following:
• From the printer control panel, touch Continue to print the part of the job already stored and begin collating the
rest of the print job.
• Cancel the current print job.
Insufficient memory to support Resource Save feature [35]
Install additional printer memory or touch Continue to disable Resource Save, clear the message, and continue printing.
Insufficient memory, some Held Jobs were deleted [37]
From the printer control panel, touch Continue to clear the message.
Insufficient memory, some held jobs will not be restored [37]
Try one or more of the following:
• From the printer control panel, touch Continue to clear the message.
• Delete other held jobs to free up additional printer memory.
Insufficient space between paper stacks in Tray 3
Move the paper stacks apart, and then touch Continue on the control panel to clear the message and continue printing.
7421
Diagnostic information
123