6 Remove the seven screws (A).
A
7 Disconnect the cables within the frame, and then release them from the guides.
8 Remove the frame.
Fuser power supply fan removal
1 Remove the scanner interface cable cover. See “Scanner interface cable cover removal” on page 344.
2 Remove the controller board access cover. See “Controller board access cover removal” on page 345.
3 Remove the engine board cover. See “Engine board cover removal” on page 346.
4 Remove the upper rear cover. See “Upper rear cover removal” on page 346.
5 Remove the IHPS shield. See “IHPS shield removal” on page 347.
7421
Repair information
361
To Next Page
Loading...
