Actions Yes No
Step 7
Enter the Diagnostics menu, and then navigate to:
SENSOR TESTS > 2500-Sheet Tray Sensor Tests
Does the sensor status change while toggling the sensor?
Go to step 9. Go to step 8.
Step 8
a Make sure that the sensor cables are properly installed.
b Make sure to route the cables properly.
c Make sure to reseat the cables on the 2500-sheet tray controller board
and the sensors.
d Make sure to reseat the junction connectors of the cables.
e Make sure that the cables do not snag on moving objects.
f Check the cables for damage, and replace if necessary.
Does the problem remain?
Go to step 9. The problem is solved.
Step 9
a Remove the tray insert.
b Make sure that the sensor (transfer guide home) and sensor (2500-
sheet tray elevator home) are properly installed.
c Check the sensors for damage, and replace if necessary. See “Sensor
(2500‑sheet tray transfer guide home) removal” on page 470 and
“Sensor (2500‑sheet tray elevator home) removal” on page 465.
Does the problem remain?
Contact the next level
of support.
The problem is solved.
600 errors
600 error messages
Error code Description Action
600.00 The image was not ready during a print job from the
MPF.
See
“Unready image service check” on page 181.
600.01 The image was not ready during a print job from tray
1.
600.02 The image was not ready during a print job from tray
2.
600.03 The image was not ready during a print job from tray
3.
600.04 The image was not ready during a print job from tray
4.
600.05 The image was not ready during a print job from tray
5.
600.10 The image was not ready during a duplex print job.
7421
Diagnostic information
180
To Next Page
Loading...
