Hard drive removal
Note: This part is not a FRU.
1 Remove the controller board cover. See “Controller board access cover removal” on page 345.
2 Disconnect the cable (A), and then remove the two screws (B).
3 Remove the hard drive.
Controller board removal
Warning—Potential Damage: Do not replace the engine controller board and controller board at the same time.
Before removing the controller board, copy its settings to the engine board to avoid losing its original settings. See
“Restore Backup Data” on page 225.
Note: Back up the eSF solutions and settings before replacing the controller board. For more information, see
“Backing up eSF solutions and settings” on page 247.
1 Remove the controller board access cover. See “Controller board access cover removal” on page 345.
2 Remove the ADF/scanner image controller board. See “ADF/scanner image controller board removal” on page
354.
3 Remove the hard drive. See “Hard drive removal” on page 356.
7421
Repair information
356
To Next Page
Loading...
