7 Remove the screw (A), and then remove the guide.
8 Disconnect the cable (B), and then remove the four screws (C).
9 Slightly lift the motor to release, and then remove it.
Fuser drive gearbox removal
1 Remove the port access door. See “Port access door removal” on page 278.
2 Remove the scanner interface cable cover. See “Scanner interface cable cover removal” on page 344.
3 Remove the controller board access cover. See “Controller board access cover removal” on page 345.
4 Remove the engine board cover. See “Engine board cover removal” on page 346.
7421
Repair information
385
To Next Page
Loading...
