4 Remove the scanner interface cable cover. See “Scanner interface cable cover removal” on page 344.
5 Remove the upper rear cover. See “Upper rear cover removal” on page 346.
6 Open the controller board frame. See “Controller board frame removal” on page 365.
7 Remove the tray 2 transport drive. See “Tray 2 transport drive removal” on page 373.
8 Remove the two screws, and then remove the motor.
Feed drive assembly removal
1 Remove the port access door. See “Port access door removal” on page 278.
2 Remove the controller board access cover. See “Controller board access cover removal” on page 345.
3 Remove the engine board cover. See “Engine board cover removal” on page 346.
4 Remove the scanner interface cable cover. See “Scanner interface cable cover removal” on page 344.
5 Remove the upper rear cover. See “Upper rear cover removal” on page 346.
6 Open the controller board frame. See “Controller board frame removal” on page 365.
7 Slightly lift the cable guide (A) to release. Move the guide to access the screw behind it.
8 Disconnect the cable (B), and then remove the six screws (C).
9 Remove the assembly.
7421
Repair information
375
To Next Page
Loading...
