Entering Safe Mode (EverReady Mode)
This mode enables the printer to temporarily offer minimal print capabilities.
1 Turn off the printer.
2 Press and hold 7 and 6 while turning on the printer.
3 Release the buttons after 10 seconds.
Accessing the Network SE Menu
This menu contains settings for fine tuning the communication settings for the network interfaces and protocols.
1 Navigate to:
Networks/Ports > Standard Network > Standard Network Setup
2 Press and hold 6, 7, and 9.
Service Engineer menu
Accessing the Service Engineer (SE) Menu
From a Web browser on a host computer, add /se to the printer IP address.
Service Engineer (SE) Menu
Use this menu as directed by the next level of support.
Top level menu Intermediate menu
Print SE Menus ‑‑
General Copyright
Code Revision Info
• Network Code Level
• Network Compile Info
• Printer Code Level
• Printer Compile Info
History
• Print History
• Mark History
• History Mode
MAC
• Set Card Speed
• LAA
• Keep Alive
NVRAM
• Dump NVRAM
• Reinit NVRAM
7421
Service menus
238
To Next Page
Loading...
