This menu appears as a soft button at the bottom right corner of the display.
Configuration Menu
Entering the Configuration menu
1 Turn off the printer.
2 Press and hold 2 and 6 while turning on the printer.
Release the buttons when the splash screen appears.
Hole Punch Configuration
The values in this setting determine which values appear in the Hole Punch Mode setting and which value is the default.
1 Enter the Configuration menu, and then select Hole Punch Configuration.
2 Select from the following options:
• 2/3-hole—Only the 2 holes and 3 holes values appear. The 3 holes value is the default.
• 2/4-hole—Only the 3 holes and 4 holes values appear. The 4 holes value is the default.
• Swedish—Only the 4 holes value appears.
• Japanese—Only the 2 holes value appears.
3 Apply the changes.
Reset Maintenance Counter
This setting resets the selected maintenance count value to zero.
1 Enter the Configuration menu, and then select Reset Maintenance Counter.
2 Select the maintenance kit to reset.
USB Scan to Local
This setting determines whether the USB device driver enumerates as a USB Simple device (single interface) or as a
USB Composite device (multiple interfaces).
1 Enter the Configuration menu, and then select USB Scan to Local.
2 Select a setting.
3 Apply the changes.
Print Quality Pages
This setting prints a report that contains a limited set of the information that appears in the Diagnostics version of the
Print Quality Pages report. See
“Print Quality Pages” on page 214.
Enter the Configuration menu, and then select Print Quality Pages.
7421
Service menus
229
To Next Page
Loading...
