PRINTER SETUP
Defaults
Warning—Potential Damage: Modifying printer setting defaults restores the NVRAM space to its factory settings.
This setting determines whether the printer uses the U.S. or Non-U.S. factory default value for the following settings:
Printer default values U.S. value Non-U.S. value
Paper Sizes setting in the General Settings menu U.S. Metric
Default Paper Size (paper feeding sources which do not
have hardware size sensing capabilities)
Letter A4
Default Envelope Size (envelope feeding sources which do
not have hardware size sensing capability)
10 Envelope DL Envelope
Fax Paper Size Letter A4
PCL Symbol Set PC-8 PC-850
PPDS Code Page 437 850
Universal Units of Measure Inches Millimeters
1 Enter the Diagnostics menu, and then navigate to:
PRINTER SETUP > Defaults
2 Select a default value.
3 Apply the changes.
Printed Page Count
This setting gauges the amount of usage on the printer. The value of the Printed Page Count setting equals the value
of the Picked Sides meter. After all print tests are completed, the value resets to zero.
Enter the Diagnostics menu, and then navigate to:
PRINTER SETUP > Printed Page Count
Note: The value of the setting cannot be changed manually.
Permanent Page Count (Perm page count)
This setting indicates the number of pages that are printed. After all print tests are completed, the value resets to zero.
Enter the Diagnostics menu, and then navigate to:
PRINTER SETUP > Perm Page Count
Note: The Permanent Page Count value cannot be reset.
Processor ID
This setting indicates the ID of the processor on the controller board.
Enter the Diagnostics menu, and then navigate to:
7421
Service menus
224
To Next Page
Loading...
