Min Copy Memory
This setting determines how much DRAM is allowed to be stored in the priority queue for copy jobs.
Note: The values appear only if the amount of installed DRAM is at least twice the amount of the value.
1 Enter the Configuration menu, and then select Min Copy Memory.
2 Select a setting.
3 Apply the changes.
NumPad Job Assist
This setting determines if you can configure and initiate a job using the hard buttons of the control panel.
1 Enter the Configuration menu, and then select NumPad Job Assist.
2 Select a setting.
3 Apply the changes.
Format Fax Storage
This setting enables you to format the non-volatile storage for faxes.
1 Enter the Configuration menu, and then select Format Fax Storage.
Note: If an advanced password has been established, then enter the password to change the setting. If no
advanced password exists, then establish one by using the keyboard that appears on the screen.
2 Apply the changes.
Fax Storage Location
This setting allows you to store faxes on the hard disk or NAND.
Note: This setting appears only if a hard disk is installed. The printer automatically stores all buffered faxes on NAND
when no hard disk is installed.
1 Enter the Configuration menu, and then select Fax Storage Location.
2 Select a setting.
3 Apply the changes.
ADF Edge Erase
This setting sets the size of the no-print area around an ADF scan job.
1 Enter the Configuration menu, and then select ADF Edge Erase.
2 Select a setting.
3 Apply the changes.
7421
Service menus
232
To Next Page
Loading...
