Lexmark MX912dxe - Replace Jammed Originals if Restarting Job; Replace [X] Maintenance Kit, 0 Estimated Pages Remain [80.Xy]; Replace Missing Photoconductor [31.Xy]; Replace Missing Waste Toner Bottle [82.Xy]

Notes:
• The x and y values represent .xy in the code that appears on the printer control panel.
• The x and y values must match for printing to continue.
Replace jammed originals if restarting job
Try one or more of the following:
• Touch Cancel job to clear the message and cancel the scan job.
• Touch Scan from automatic feeder to continue scanning from the ADF immediately after the last successful scan
job.
• Touch Scan from flatbed to continue scanning from the scanner immediately after the last successful scan job.
• Touch Finish job without further scanning to end the last successful scan job.
• Touch Restart job to restart the scan job with the same settings from the previous scan job.
Replace [x] maintenance kit, 0 estimated pages remain [80.xy]
The printer is scheduled for maintenance. For more information, go to http://support.lexmark.com or contact your
service representative, and then report the message.
Replace missing photoconductor [31.xy]
Install the missing photoconductor unit to clear the message.
Replace missing waste toner bottle [82.xy]
Install the missing waste toner bottle to clear the message. For more information, see the instruction sheet that came
with the supply.
Replace missing cartridge [31.xy]
Install the missing cartridge to clear the message.
Replace paper pick rollers in [paper source], use parts and instructions in tray 1 or
tray 2 compartment [80]
Try one or more of the following:
• Replace the pick rollers, and then touch Rollers replaced on the control panel to clear the message and continue
printing.
• Touch Continue and replace later (Jams may continue to occur) to ignore the message and continue printing.
Replace photoconductor, 0 pages remain [84.xy]
Replace the photoconductor unit to clear the message and continue printing.
7421
Diagnostic information
130