Motor (scanner drive) removal
Note: Make sure to perform scanner carriage belt adjustment after replacing the motor (scanner drive). See
“Scanner carriage belt adjustment” on page 267.
1 Remove the ADF assembly. See “ADF assembly removal” on page 391.
2 Remove the scanner rear cover. See “Scanner rear cover removal” on page 430.
3 Disconnect the cable (A), remove the spring (B), and then remove the three screws (C).
4 Remove the motor.
Control panel base removal
1 Remove the control panel bottom cover. See “Control panel bottom cover removal” on page 442.
2 Remove the speaker cover. See “Speaker cover removal” on page 338.
3 Remove the speaker frame.
4 Remove the control panel. See “Control panel removal” on page 341.
7421
Repair information
440
To Next Page
Loading...
