Lexmark MX912dxe - Diagnostics Menu; Entering the Diagnostics Menu; Reset Separator Roll and Pick Assembly Counter; Reset Maintenance Counter

Paper Menu Reports Network/Ports Security
Settings Help Manage Shortcuts
Option Card Menu
2
General Settings
Copy Settings
Fax Settings
E‑mail Settings
FTP Settings
Flash Drive Menu
Print Settings
Print All Guides
Copy Guide
E-mail Guide
Fax Guide
FTP Guide
Print Defects Guide
Information Guide
Supplies Guide
Fax Shortcuts
E-mail Shortcuts
FTP Shortcuts
Copy Shortcuts
Profile Shortcuts
A list of installed DLEs (Download
Emulators) appears.
1
Depending on the printer setup, this menu appears as Standard Network or Network [x].
2
This menu appears only when one or more DLEs are installed.
Diagnostics Menu
Entering the Diagnostics menu
1 Turn off the printer.
2 Press and hold 3 and 6 while turning on the printer.
Release the buttons when the splash screen appears.
Reset Separator Roll and Pick Assembly Counter
This setting resets the value of the counter that tracks the usage of the 200K ADF maintenance kit.
Reset Maintenance Counter
This setting resets the value of the counter that tracks the usage of the multipurpose feeder maintenance roller kit.
1 Enter the Diagnostics menu, and then select Reset Maintenance Counter.
2 Select the kit to reset.
Reset Fuser Counter
This setting resets the fuser counter to zero.
Note: This setting appears only if the Maintenance Warning and Intervention configuration ID bit is enabled.
Enter the Diagnostics menu, and then select Reset Fuser Counter.
7421
Service menus
212