Toner suction fan removal
1 Remove the left cover. See “Left cover removal” on page 272.
2 Remove the rear left cover. See “Rear left cover removal” on page 273.
3 Remove the port access door. See “Port access door removal” on page 278.
4 Remove the controller board access cover. See “Controller board access cover removal” on page 345.
5 Remove the engine board cover. See “Engine board cover removal” on page 346.
6 Remove the scanner interface cable cover. See “Scanner interface cable cover removal” on page 344.
7 Remove the upper rear cover. See “Upper rear cover removal” on page 346.
8 Disconnect the cable (A), and then remove the two screws (B).
7421
Repair information
387
To Next Page
Loading...
