7 Remove the two screws (A), remove the bracket, and then remove the clip (B).
8 Remove the clutch.
Motor (fuser) removal
1 Remove the port access door. See “Port access door removal” on page 278.
2 Remove the scanner interface cable cover. See “Scanner interface cable cover removal” on page 344.
3 Remove the controller board access cover. See “Controller board access cover removal” on page 345.
4 Remove the engine board cover. See “Engine board cover removal” on page 346.
5 Remove the upper rear cover. See “Upper rear cover removal” on page 346.
6 Remove the IHPS shield. See “IHPS shield removal” on page 347.
7421
Repair information
384
To Next Page
Loading...
