Lexmark MX912dxe - Scheduled Maintenance; Maintenance Kits

PART EVERY 50K EVERY 300K EVERY 600K EVERY 720K
FUSER
Fuser ‑‑ ‑‑ ‑‑
Replace
6
Induction heater
7
‑‑ ‑‑ ‑‑
Clean
8
DUPLEX TRANSPORT
Transport rollers
Clean
2
‑‑ ‑‑ ‑‑
1
For 500‑sheet trays, if jams still occur after 80K, then replace using the spare rollers in the tray compartment.
2
Use damp cloth.
3
Use brush.
4
Reset 300K Maintenance kit.
5
Reset 600K Maintenance kit.
6
Reset Fuser kit.
7
Clean when fuser is replaced.
8
Use dry cloth.
PART EVERY 50K EVERY 200K
ADF ASSEMBLY
Feed, separator, and pick rollers
Clean
1
Replace
3
Glass clean rollers
Clean
1
‑‑
Sensors (photo reflective)
Clean
2
‑‑
1
Use damp cloth.
2
Use brush.
3
Reset separator roll and pick assembly counter.
Scheduled maintenance
The control panel displays an 80.xx error when the printer reaches a preset number of page counts. It is necessary to
install the appropriate maintenance kit to maintain the print quality and reliability of the printer. Reset the maintenance
counter after replacing the maintenance kit.
Maintenance kits
Part number and kit Contents
40X9672—200K ADF Maintenance kit
• ADF pick roller
• ADF feed roller
• ADF separator roller
40X9673—200K MPF Maintenance kit
• MPF feed roller
• MPF separator roller
7421
Maintenance
534