Unsupported option in slot [x] [55]
1 Turn off the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the unsupported option card from the printer controller board, and then replace it with a supported card.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
Waste toner bottle nearly full [82.xy]
You may need to order a waste toner bottle. If necessary, touch Continue on the printer control panel to clear the
message and continue printing.
Weblink server not set up. Contact system administrator.
From the printer control panel, touch Continue to clear the message.
Note: If the message appears again, then contact your system support person.
User attendance messages
User attendance messages (0‑99)
Error code Description Action
31 A supply‑related error was detected:
• The cartridge is missing or undetected.
• The photoconductor is missing or undetected.
• The cartridge is defective.
• The photoconductor is defective.
See
“Cartridge or photoconductor error service
check” on page 135.
32 The cartridge or photoconductor is unsupported.
34 Paper size mismatch was detected. See
“Mismatched paper size service check” on
page 136.
35 The printer memory is insufficient to enable
Resource Save.
See
“Insufficient memory service check” on
page 137.
37 The printer memory was insufficient to do the job.
38 Memory is full.
39 The page is too complex to print. See
“Complex page service check” on page 137.
42 The cartridge is incompatible due to printer region
mismatch.
See
“Cartridge or photoconductor error service
check” on page 135.
50 PPDS encountered a font error. See
“PPDS font error service check” on page 138.
7421
Diagnostic information
134
To Next Page
Loading...
