Lexmark MX912dxe - Induction Heater Power Supply (IHPS) Removal; Noise Filter Board Removal

Induction heater power supply (IHPS) removal
1 Remove the scanner interface cable cover. See “Scanner interface cable cover removal” on page 344.
2 Remove the controller board access cover. See “Controller board access cover removal” on page 345.
3 Remove the engine board cover. See “Engine board cover removal” on page 346.
4 Remove the upper rear cover. See “Upper rear cover removal” on page 346.
5 Remove the induction heater power supply shield. See “IHPS shield removal” on page 347.
6 Remove the induction heater magnetic erase board. See “Induction heater magnetic erase board (IHMEB) removal”
on page 348.
7 Disconnect the cables, and then remove the eight screws (A).
8 Remove the power supply.
Noise filter board removal
1 Remove the scanner interface cable cover. See “Scanner interface cable cover removal” on page 344.
2 Remove the controller board access cover. See “Controller board access cover removal” on page 345.
3 Remove the engine board cover. See “Engine board cover removal” on page 346.
4 Remove the upper rear cover. See “Upper rear cover removal” on page 346.
5 Remove the IHPS shield. See “IHPS shield removal” on page 347.
7421
Repair information
350