5 Remove the seven screws (A), and then remove the shield.
Induction heater magnetic erase board (IHMEB) removal
1 Remove the scanner interface cable cover. See “Scanner interface cable cover removal” on page 344.
2 Remove the controller board access cover. See “Controller board access cover removal” on page 345.
3 Remove the engine board cover. See “Engine board cover removal” on page 346.
4 Remove the upper rear cover. See “Upper rear cover removal” on page 346.
5 Remove the induction heater power supply shield. See “IHPS shield removal” on page 347.
6 Disconnect the four cables (A).
7421
Repair information
348
To Next Page
Loading...
