Fuser removal
1 Open the right door.
2 Remove the three screws (A). Remove the fuser connector cover, and then disconnect the three fuser cables (B).
3 Remove the fuser.
Note: If the fuser rollers are not retracted, the fuser may be hard to remove. To retract the fuser roller, turn on
the printer to initiate warm‑up, and then turn off the printer.
Induction heater removal
1 Remove the scanner interface cable cover. See “Scanner interface cable cover removal” on page 344.
2 Remove the controller board access cover. See “Controller board access cover removal” on page 345.
3 Remove the engine board cover. See “Engine board cover removal” on page 346.
4 Remove the upper rear cover. See “Upper rear cover removal” on page 346.
5 Remove the induction heater power supply shield. See “IHPS shield removal” on page 347.
6 Remove the fuser. See “Fuser removal” on page 279.
7 Remove the left cover. See “Left cover removal” on page 272.
8 Remove the standard bin base. See “Standard bin base removal” on page 389.
7421
Repair information
279
To Next Page
Loading...
