5 Disconnect the four cables (A), and then remove the two screws (B).
6 Remove the cover.
IHPS shield removal
Note: This part is not a FRU.
1 Remove the scanner interface cable cover. See “Scanner interface cable cover removal” on page 344.
2 Remove the controller board access cover. See “Controller board access cover removal” on page 345.
3 Remove the engine board cover. See “Engine board cover removal” on page 346.
4 Remove the upper rear cover. See “Upper rear cover removal” on page 346.
7421
Repair information
347
To Next Page
Loading...
