Lexmark MX912dxe - Adf;Scanner Hardware Errors; Error Messages

ADF/scanner hardware errors
800 error messages
Error code Description Action
800.04 A timing error occurred during a scan job at the
front side of the document.
See
“ADF controller board service check” on
page 194.
800.15 The CIS clamp adjustment failed. See
“ADF CIS service check” on page 196.
800.16 The CIS gain adjustment failed.
800.23 A timing error occurred during a scan job at the
back side of the document.
See
“Scanner controller board service
check” on page 197.
800.25 The CCD power supply malfunctioned. See
“Scanner CCD service check” on
page 198.
800.7 The image data was not detected. See
“Scanner controller board service
check” on page 197.
809 error messages
Error code Description Action
809 Scanner controller board was not detected. See
“Scanner controller board service
check” on page 197.
809.01 The scanner controller board communication
failed.
809.02 The scanner controller board communication
failed.
809.03 ADF controller board was not detected. See
“ADF controller board service check” on
page 194.
809.04 The ADF controller board communication
failed.
809.05 The ADF controller board communication
failed.
809.06 Scanning speed went over the required level.
7421
Diagnostic information
192