2 x 500-sheet tray transport assembly sensors removal
Note: The following procedure begins with the tray 4 transport assembly sensors. If you are removing the tray 3
transport assembly sensors, then go directly to step 5.
1 Remove the rear right cover. See “2 x 500-sheet tray rear right cover removal” on page 489.
2 Remove the jam access door. See “2 x 500-sheet tray jam access door removal” on page 488.
3 Remove the bottom right cover. See “2 x 500-sheet tray bottom right cover removal” on page 490.
4 Remove the tray 4 transport assembly. See “2 x 500-sheet tray 4 transport assembly removal” on page 491.
5 Remove the appropriate FRU.
7421
Repair information
492
To Next Page
Loading...
