Lexmark MX912dxe - Sensor (Fusing Speed) Removal; Fusing Speed Actuator Removal

Sensor (fusing speed) removal
1 Remove the registration unit assembly. See “Registration unit assembly removal” on page 314.
2 Remove the registration unit sub-assembly. See “Registration unit sub-assembly removal” on page 315.
3 Disconnect the cable (A), and then remove the sensor.
Fusing speed actuator removal
Note: This part is not a FRU.
1 Remove the registration unit assembly. See “Registration unit assembly removal” on page 314.
2 Remove the registration unit sub-assembly. See “Registration unit sub-assembly removal” on page 315.
3 Release the spring (A), and then remove the actuator.
7421
Repair information
317