5 Open the port access door, and then remove the two screws (A).
A
6 Disconnect the cable (B), and then remove the card.
B
Motor (fuser pressure) removal
1 Remove the scanner interface cable cover. See “Scanner interface cable cover removal” on page 344.
2 Remove the controller board access cover. See “Controller board access cover removal” on page 345.
3 Remove the engine board cover. See “Engine board cover removal” on page 346.
4 Remove the upper rear cover. See “Upper rear cover removal” on page 346.
7421
Repair information
358
To Next Page
Loading...
