EasyManua.ls Logo

Lexmark MX912dxe - Device Tests

Lexmark MX912dxe
827 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3 Check if the motor runs.
Booklet Maker Motor Tests
These tests verify that the booklet maker motors are working properly.
1 Enter the Diagnostics menu, and then navigate to:
Motor Tests > Booklet Maker Motor Tests
2 Select a motor.
3 Check if the motor runs.
DEVICE TESTS
Quick Disk Test
This test performs a non-destructive read/write test on one block per track on the disk. If the block is good, then the
saved data is written back to the disk.
1 Enter the Diagnostics menu, and then navigate to:
DEVICE TESTS > Quick Disk Test
2 Exit the test.
Disk Test/Clean
Warning—Potential Damage: This test destroys all data on the printer hard disk.
This test may run for approximately 1.5 hours depending on the disk size.
1 Enter the Diagnostics menu, and then navigate to:
DEVICE TESTS > Disk Test/Clean
You cannot cancel the test once it has started.
2 Exit the test.
Flash Test
This test examines the condition of the flash drive.
Warning—Potential Damage: This test destroys all data on the flash drive.
1 Enter the Diagnostics menu, and then navigate to:
Device Tests > Flash Test
You cannot cancel the test once it has started.
2 Exit the test.
3 Reformat the flash drive using the Flash Format setting in the Utilities menu.
7421
Service menus
223

Table of Contents

Related product manuals