7 Disconnect the cable (A), and then remove the four screws (B).
High voltage board removal
1 Remove the port access door. See “Port access door removal” on page 278.
2 Remove the controller board access cover. See “Controller board access cover removal” on page 345.
3 Remove the engine board cover. See “Engine board cover removal” on page 346.
4 Remove the scanner interface cable cover. See “Scanner interface cable cover removal” on page 344.
5 Remove the upper rear cover. See “Upper rear cover removal” on page 346.
6 Open the controller board frame. See “Controller board frame removal” on page 365.
7421
Repair information
369
To Next Page
Loading...
