3 Select Flatbed.
The current values of the left margin and right margin registration settings appear.
4 Adjust the left and right margins.
5 Apply the changes.
6 Repeat step 2 to view the updated values.
7 Repeat steps 3 through 5 to make further adjustments.
Fuser alignment adjustment
Fuser misalignment may cause wrinkles on the paper. Perform this procedure to align the fuser with the registration
unit assembly.
1 Remove the fuser. See “Fuser removal” on page 279.
2 Remove the two screws (A), and then remove the fuser mount.
3 Add or decrease the number of plates to adjust the position of the fuser.
Notes:
• A single plate (B) has a thickness of 0.6 mm.
• The default number of plates is 1.
7421
Repair information
262
To Next Page
Loading...
