5 Disconnect the cable (A), and then remove the two screws (B).
B
A
6 Remove the motor.
Paper exit fan duct removal
1 Remove the scanner interface cable cover. See “Scanner interface cable cover removal” on page 344.
2 Remove the controller board access cover. See “Controller board access cover removal” on page 345.
3 Remove the engine board cover. See “Engine board cover removal” on page 346.
4 Remove the upper rear cover. See “Upper rear cover removal” on page 346.
5 Remove the four screws (A), and then remove the duct.
A
7421
Repair information
359
To Next Page
Loading...
