Lexmark MX912dxe - Toner Specks Check

Actions Yes No
Step 4
a Make sure that the induction heater is properly installed.
b Reseat the heater cable.
c Check the heater and its cable for damage, and replace if necessary.
See
“Induction heater removal” on page 279.
Does the problem remain?
Go to step 5. The problem is solved.
Step 5
a Make sure that the induction heater power supply is properly
installed.
b Reseat the power supply cables.
c Check the power supply and its cables for damage, and replace if
necessary. See
“Induction heater power supply (IHPS) removal” on
page 350.
Does the problem remain?
Contact the next level
of support.
The problem is solved.
Toner specks check
Actions Yes No
Step 1
a Make sure that the photoconductor and printhead are clean.
b Make sure that the photoconductor and printhead are properly
installed.
c Check the photoconductor for damage, and replace if necessary.
Does the problem remain?
Go to step 2. The problem is solved.
Step 2
a Make sure that the cartridge and photoconductor are installed.
b Make sure that the cartridge and photoconductor are supported.
Does the problem remain?
Go to step 3. The problem is solved.
7421
Diagnostic information
58