Lexmark MX912dxe - Input Tray Tests; Output bin Tests

Top Margin
This setting controls the offset between the placement of the first scan line on both sides of a duplexed sheet.
Note: If adjustment is necessary, adjust first the top margin in the Registration menu. You can adjust next the duplex
top margin.
1 Enter the Diagnostics menu, and then navigate to:
DUPLEX TESTS > Top Margin
2 Change the margin values.
Changing the value by 1 unit moves the margin by 1/100 inch. A positive value moves the text down the page and
widens the top margin. A negative value moves the text up the page and narrows the top margin.
3 Apply the changes.
INPUT TRAY TESTS
Feed Tests
This test feeds blank pages through the paper path.
1 Enter the Diagnostics menu, and then navigate to:
INPUT TRAY TESTS > Feed Tests
2 Select the input source.
All installed sources appear.
3 Select any of the following:
• Single—This option feeds a single page.
• Continuous—This option continuously feeds pages until X is pressed.
OUTPUT BIN TESTS
Feed Tests
This test verifies if paper can be fed to a specific output bin. No information is printed on the paper.
1 Enter the Diagnostics menu, and then navigate to:
OUTPUT BIN TESTS > Feed Tests
2 Select the output bin.
All installed output bins appear.
3 Select one of the following:
• Single—This option feeds a single page.
• Continuous—This option continuously feeds pages until X is pressed.
7421
Service menus
217