Center cable guide bracket removal
Note: This part is not a FRU.
1 Remove the port access door. See “Port access door removal” on page 278.
2 Remove the controller board access cover. See “Controller board access cover removal” on page 345.
3 Remove the engine board cover. See “Engine board cover removal” on page 346.
4 Remove the scanner interface cable cover. See “Scanner interface cable cover removal” on page 344.
5 Remove the upper rear cover. See “Upper rear cover removal” on page 346.
6 Open the controller board frame. See “Controller board frame removal” on page 365.
7 Remove the four screws (A), and then release the cables from the bracket cable clips.
A
8 Remove the bracket.
Main drive assembly removal
1 Remove the port access door. See “Port access door removal” on page 278.
2 Remove the controller board access cover. See “Controller board access cover removal” on page 345.
3 Remove the engine board cover. See “Engine board cover removal” on page 346.
4 Remove the scanner interface cable cover. See “Scanner interface cable cover removal” on page 344.
5 Remove the upper rear cover. See “Upper rear cover removal” on page 346.
6 Open the controller board frame. See “Controller board frame removal” on page 365.
7 Remove the center cable guide bracket. See “Center cable guide bracket removal” on page 379.
8 Remove the high voltage board. See “High voltage board removal” on page 369.
7421
Repair information
379
To Next Page
Loading...
