# Part
1 Sensor (3000-sheet tray near empty 1)
2 Sensor (3000-sheet tray near empty 2)
Motor bracket removal
Note: This part is not a FRU.
1 Remove the right cover. See “3000-sheet tray right cover removal” on page 505.
2 Remove the rear cover. See “3000-sheet tray rear cover removal” on page 506.
3 Disconnect the four cables (A).
4 Remove the ten screws (B), and then remove the bracket.
B
A
B
A
3000-sheet tray feed and transport motors removal
1 Remove the right cover. See “3000-sheet tray right cover removal” on page 505.
2 Remove the rear cover. See “3000-sheet tray rear cover removal” on page 506.
3 Remove the motor bracket. See “Motor bracket removal” on page 519.
7421
Repair information
519
To Next Page
Loading...
