Starting the engine for driving – switching it off
4.1 Starting the engine from the driver's cab
4 - 14 3 302 736 en Operating manual
GMK4090
xx.xx.xxxx
4.1.8 Starting the engine
H
This section describes only how to start the engine from the driver's cab.
You can also start the engine from the outrigger control units;
à p. 12 - 27.
Refer to the separate operating manual provided by the engine manufac-
turer for operating the engine. The engine can only be started if:
– The bridging plugs have been inserted in all sockets of the carrier and
superstructure for the hand-held control;
à p. 9 - 82.
– The lamp (1) has gone out (superstructure ignition off).
– The parking brake must be applied.
– The transmission must be in position N; à p. 5 - 26.
To Next Page
Loading...
