Driving with a rigged truck crane
13.5 Driving from the crane cab
13 - 28 3 302 736 en Operating manual
GMK4090
xx.xx.xxxx
13.5.6 Possible connections
You can make the following connections, one
after the other:
– Longitudinal differential locks (2)
– Transverse differential locks (1)
The symbols indicate the current switching
state.
Longitudinal/
transverse differ-
ential locks
With an 8 x 8 x 8 drive, the drive of the 2nd axle line is switched on and off
together with the longitudinal differential locks.
• Straighten the steering.
• Stop the truck crane.
For switching on and off, the current speed needs to be under about 5 km/h
(3 mph).
S
Risk of damage to the differential locks
Leave the transverse differential locks switched on only for as long as nec-
essary. Always switch off the transverse differential locks before driving on
a firm surface.
To Next Page
Loading...
