Driving modes
6.1 Driving modes
Operating manual 3 302 736 en 6 - 1
GMK4090
xx.xx.xxxx
6 Driving modes
This chapter contains tables with driving modes of the GMK4090, for which
the maximum axle load is 12 t (26,500 lbs).
6.1 Driving modes
Information about
the axle loads
The GMK4090 truck crane is designed for driving with maximum axle loads
of 12 t (26,500 lbs).
Manitowoc Crane Group Germany GmbH notes that driving
with an axle load exceeding 12 t (26,500 lbs) the brake system can overheat
and the braking deceleration required by the EU partial type-approval can-
not be ensured.
If country-specific regulations allow the truck crane to be driven with axle
loads greater that 12 t (26,500 lbs), the crane driver/operator bears the sole
responsibility for driving in this condition and for any subsequent damage.
This also applies to damage due to premature wear.
G
Risk of accidents from increased braking distance
When driving with axle loads in excess of 12 t (26,500 lbs), the braking
deceleration required by the EU partial type-approval cannot be met. Please
bear in mind that the braking distance of the truck crane will be increased.
S
Risk of damage from premature wear
Premature wear of parts under particular strain (brake system, steering,
tyres, wheels, suspension, drive shafts) cannot be ruled out even if the axle
loads only briefly exceed 12 t (26,500 lbs).
To Next Page
Loading...
Need help?
General
