Rigging work
12.11 Other rigging work
Operating manual 3 302 736 en 12 - 159
GMK4090
xx.xx.xxxx
12.11.5 Step at the crane cab
You can pull out the stair tread for crane operation.
For driving operation you must slide in the step.
The spring latch (3) is on the right outside at
the step.
Extending
• Pull the spring latch (3) and pull out the stair
tread (1) by the handle (2) at the same time
until the spring latch (3) latches into place.
Retracting
Retracting is performed in the reverse
sequence.
s
G
Risk of accidents by exceeding the permissible overall width
Always slide in the step for on-road driving.
When the step is extended, the overall width specified for on-road driving
is exceeded.
G
Risk of accidents during on-road driving due to the step moving out
Always secure the retracted step using the spring latch.
This prevents the step from sliding out by itself during cornering.
G
Risk of injury when the step is pulled out
Do not operate the step when you are on the access ladder In this way you
avoid losing your grip and falling from the access ladder.
To Next Page
Loading...
