Manitowoc GROVE GMK4090 - Preparing to Drive; Opening;Closing the Driving Menu

Driving with a rigged truck crane
13.5 Driving from the crane cab
13 - 16 3 302 736 en Operating manual
GMK4090
xx.xx.xxxx
13.5.1 Preparing to drive
•
Make sure that the rigging mode for driving with a load or without a load
is set correctly;
à p. 13 - 2.
In the driver's cab
– The ignition key must be in position 1 so that the steering cannot block.
– The driver's cab must be locked with the second ignition key in order to
secure it against unauthorised use – for example, braking.
– The parking brake is engaged.
In the crane cab
– The ignition must be switched on.
– The hand-held control must be disconnected and bridging plugs plugged
into all the sockets.
– The superstructure must be locked.
– The parking brake is engaged.
13.5.2 Opening/closing the driving menu
Opening the menu
• Select and confirm the symbol (1).
The menu opens automatically the first time you release the parking brake
after switching on the ignition.
The display will show (A) or (B) depending on
the current slewing angle;
Carrier display,
p. 9 - 155.
If the symbol (1) is red, you must turn the ignition key in the driver's cab to
position 1 – the symbol then turns grey.