Driving
5.3 Driving the truck crane and switching it off
5 - 44 3 302 736 en Operating manual
GMK4090
xx.xx.xxxx
5.3.5 Driving uphill
Starting The engine must be running.
To start moving forwards you must do the following:
– Shift into D position
– Apply the parking brake
– Press the accelerator
– Release the parking brake after the clutch has engaged
H
Pay attention to any messages appearing on the on-board computer display
when starting driving;
à p. 8 - 9.
• Follow the instructions that are displayed and perform the specified
measures in good time.
To start reversing you must do the following:
– Shift into position R
– Release the parking and service brakes
– Apply the accelerator if you wish to accelerate
– Do not apply the accelerator if you wish to brake with the engine.
Driving On certain gradients, the transmission may switch continuously back and
forth between two gears. In this event, either release the accelerator slightly
or downshift by one gear.
G
Danger of the truck crane starting to roll away unexpectedly
When starting to move forwards, always keep the truck crane stationary
with the parking brake until the transmission is engaged. If the truck crane
starts to roll away before this (when changing from brake pedal to acceler-
ator), no gear will be engaged, and you can stop the truck crane only by
braking.
To Next Page
Loading...
