Starting the engine for driving – switching it off
4.1 Starting the engine from the driver's cab
4 - 18 3 302 736 en Operating manual
GMK4090
xx.xx.xxxx
4.1.10 Setting the idling speed
After the engine is started, the idling speed is regulated automatically. If
necessary, you can adjust the idling speed manually.
H
You can only set the idling speed when the truck crane is stationary.
Increasing/reducing the idling speed
• Press the button (1) repeatedly until Engine
speed
is shown in the on-board computer dis-
play.
• Increase or decrease the speed stepwise
using the buttons (2) or (3). The engine
speed is increased/reduced by 20 rpm.
After about 3 seconds the setting is auto-
matically saved.
Switching off the idling speed change
• Press the button (1) repeatedly until Engine
speed
is shown in the on-board computer dis-
play.
• Press the button (3).
or
• Press the button (2).
or
• Accelerate to more than 20 km/h (12 mph).
To Next Page
Loading...
