Malfunctions in driving mode
8.5 Emergency operation and breakdown assistance
Operating manual 3 302 736 en 8 - 37
GMK4090
xx.xx.xxxx
8.5.5 Inflating the tyres yourself
In an emergency, if an appropriate filling hose is available you can inflate
the tyres using the compressed air system of the truck crane.
A tyre inflator connection set to a pressure of 10 bar (145 psi) is provided for
this purpose. The tyres must not be filled above this maximum pressure.
After you have inflated the tyres yourself, always drive directly to a service
station or repair shop and adjust the tyre pressure.
The filling hose has a tyre inflator connection (2) and a connection (1).
Connecting the
filling hose
• Remove the caps (2) and (4).
• Fasten the connection (3) to the filler con-
nection (1).
You can now inflate the tyres.
s
S
Risk of damage if the tyre pressure is too high!
Depending on the size of the tyres, the prescribed pressure may be less
than 10 bar (145 psi);
à Tyres, p. 1 - 16. Fill the tyres no more than the
specified pressure. If necessary, break off the filling procedure. This pre-
vents the tyres becoming damaged and bursting while driving.
To Next Page
Loading...
