Manitowoc GROVE GMK4090 - CHECKLIST: Removing the Outrigger Beams

Driving modes
6.4 Installing/removing the outrigger beams
6 - 16 3 302 736 en Operating manual
GMK4090
xx.xx.xxxx
6.4.1 CHECKLIST: Removing the outrigger beams
H
This checklist is not a complete operating manual. There are accompanying
operating instructions which are indicated by cross-references.
Observe the warnings and safety instructions specified here
1. Preparing the truck crane;
à p. 6 - 21.
2. Label the outrigger beams, retract, release and bolt them to each other;
à p. 6 - 20.
3. If necessary, remove the outrigger pads;
à p. 6 - 22.
4. Unscrew the spacer;
à p. 6 - 26.
5. – Disconnecting hydraulic connections;
à p. 6 - 24.
– Disconnect the electrical connection if necessary;
à p. 6 - 25.