Crane operation
11.8 Work break
Operating manual 3 302 736 en 11 - 147
GMK4090
xx.xx.xxxx
11.8 Work break
11.8.1 In case of short work breaks
•
Switch off the slewing gear.
– The lamp in the button (1) must be dimly lit.
– Then symbol (2) turns red – slewing gear switched off.
– Lamp (3) must light up – slewing gear brake applied.
Switch the engine off, turn the ignition key to position 0 and remove it.
Ensure that no unauthorised persons can operate the truck crane;
à To secure the truck crane, p. 11 - 148.
G
Risk of accident by suspended loads
Never switch off the engine whilst a load is suspended. You must have the
control levers at hand in order to intervene at any time.
Always set down the load before you leave the crane cab.
To Next Page
Loading...
Need help?
General
