Driving
5.3 Driving the truck crane and switching it off
Operating manual 3 302 736 en 5 - 39
GMK4090
xx.xx.xxxx
• Press the button (1) once.
Cruise control is switched on. The symbol (2) is displayed in the Driving dis-
play.
The current speed is maintained.
You can exceed this speed with the accelerator. After the accelerator is
released, cruise control reverts to the set speed.
H
On downhill slopes, the speed set may be exceeded since cruise control
does not brake the truck crane. Switch the cruise control off on downhill
slopes.
Increasing/reducing the speed
– Increase with (1)
– Reduce with (2)
• Press the corresponding button until the desired speed is reached
or
• Press the corresponding button once. The speed will increase/decrease
by 0.5 km/h (0.3 mph)
The set speed is maintained.
Switching off
• Press the button (1) once. The cruise control is now switched off. The sym-
bol (2) goes out in the Driving display.
Cruise control is also switched off,
– when the service brake or additional brake is applied
– when speed falls below 10 km/h (6 mph),
– when the Temposet function is switched on,
– when the ignition is switched off.
To Next Page
Loading...
