MASSO
MASSO Documentation
Step 3: Setting up the homing sequence
Open the Homing window.
Now in the homing sequence tick the appropriate boxes for the axis as you would like to home.
In the below example we set the homing sequence for a milling machine / router. As you would first
need to move the tool away from the job by moving the Z axis up, set Seq 1 by only selecting Z axis,
this way MASSO only homes Z axis first.
Next in Seq 2 select X and Y axis to start homing the X and Y axis together.
When an axis is slaved it will appear grayed out in the homing screen.
v5.18 - 08 Apr,2021
www.masso.com.au Page 336 of 477
To Next Page
Loading...
